7
Remove the interface cable:
1.
Find the release-hole.
2.
Insert a thin wire into the hole and pull out the cable gently.
2-5 Assembling the stand
Note: The stand is an optional accessory.
1.
See the figure above, tighten the screws.
2.
Bend the neck to the desired position for scanning.
3.
Screw mounting: Screw one #10 wood screw into each screw-mount-hole until the base of
the stand is secured.
4.
Tape mounting:
①
Peel the paper liner off one side of each piece of tape and place the
sticky surface over each of the three rectangular tape holders.
②
Peel the paper liner off
the exposed sides of each piece of tape and press the stand on a flat surface until it is
secure.
