6. Unscrew the two screws of Standard
Connection Plate from inside of printer and
remove the Standard Connection Plate.
從機器內側移除鬆開標準連接插頭遮蓋的
固定螺絲後，即可移除標準連接遮蓋。
7. Install the Rewinder Full Sensor Connector
Plate with screws that removed from
Standard Connection Plate.
換上滿紙偵測器連接遮蓋後，將遮蓋以原有
的螺絲鎖合固定。
8. Plug the connector of Rewinder Full
Sensor Connector Plate into the socket of
main board as indicated in figure.
將滿紙偵測器連接插頭遮蓋後的連接線插
上主板。
9. Unscrew the screws to remove the
Rewinder Module Cover Plate.
將機器內部側面的背紙遮蓋使用十字螺絲
起子卸下。
10. Take off the Paper Clip from the Liner
Rewind Shaft.
先將背紙回收軸桿上的
U
型固定夾取下。
11. Secure the Rewinder Module onto the
printer.
再將背紙回收模組用螺絲鎖合於機器上。
【
Note /
注意】
Before tightening screws, move the connection
wires of Rewinder Module to inside of printer.
鎖合背紙回收模組前
,
請先將模組上的連接線組
穿過安裝孔後置於機器內部。
1
2
12. After the Rewinder Module is installed,
plug the Rewinder Full Sensor Connector
into the socket on plate.
鎖合背紙回收模組後將背紙回收控制接頭
插於背紙回收控制插座上。
2
