ENG
ENG - 17
General advice
It is recommended to fill in 1.25 l at maximum. If you fill in more you are risking that according
to the consistency of the ingredients the appliance may overflow.
Switch-off the appliance as soon as the mass is treated. Under no circumstances operate the
appliance when it is empty.
Have the appliance cooled down according to the maximum operating time indicated in the
table in order not to overload the motor.
In case of larger filling quantity, the especially thin content cannot be well poured out. In this
case, it would be better to prepare the ingredients in smaller quantities.
Put the monitoring switch on 0 before taking off the glass jug.
Attention! Risk of injury! Before taking off the lid wait for the blade to stop rotating. Do not pla
-
ce hands into the jug when the appliance is connected to the electricity supply.
After use the glass jug has to be emptied completely.
Do not store any liquids in the jug.
Cleaning and maintenance
Unplug the appliance after use.
Pay attention that you do not injure yourself on the sharp blade.
Never immerse the drive unit in water, only wipe the outside with a damp cloth. Do not use
scouring cleansing agents. Pay attention that you do not injure yourself on the sharp blade
when cleaning the glass jug.
Immediately after use fill with warm water and some wash-ing-up liquid.
Then switch the appliance on for a moment. Afterwards, remove the glass jug and clean it
with a brush.
For an intensive cleaning you can remove the glass jug as described in section „Glass jug“.
Do not put the lid into the dish-washer, it might get deformed.
Troubleshooting
The device is not working
• Check that the mains connection cable is firmly plugged in.
• Check the right possitions of the glass jug on the motor unit.
• Check the positions of the speed-control cnob.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Summary of Contents for FP 121SS
Page 20: ......
