Goddess CL 4201, Instruction Manual

Page: 37 / 40

ENG
ENG - 37
Motor protection filter
The motor protection filter cleans the air that is sucked in before it enters the motor. The air is
cleaned of fine dusts, mites, bacteria and viruses. This prevents dirt or dust particles from get -
ting into the motor or the surrounding air.
Cleaning the exhaust air filter
The exhaust air filter cleans the air a final time before it leaves the vacuum cleaner. You can
clean the exhaust air filter as follows:
Switch off the vacuum cleaner and disconnect the plug from the mains. To do this always
pull on the plug and not on the cable.
Open the exhaust air grill (this is at the rear of the cyclone vacuum cleaner.)
The exhaust air filter is visible when the grill has been opened.
Rinse the filter under cold running water and allow dry.
Caution!
Only ever clean the filter with clean water and do not use soap or detergent.
These would destroy the filter.
5) Put the exhaust air filter back into place (or replace with a new one) and place in the grill.
6) Close the exhaust air filter grill.
Cleaning the Power Brush
Always unplug the power cord before cleaning the power brush. Never subject the power brush
to the weather conditions (rain, sunshine etc.). Do not use abrasive or aggressive cleaning solu -
tions! Clean the surface of the brush with soft rug. Cut tangled hair and threads with scissors.
Turn the vacuum cleaner on and vacuum the cut hair and threads.
Note!
Lubricating or greasing the wheels is not recommended.
1)
2)
3)
4)