INSTALLATION INSTRUCTIONS & IMPORTANT NOTES
1. Turn off water supply to toilet. It is usually an angle-stop/shut-off valve
on wall beneath toilet.
2. Empty toilet completely by holding flush handle down.
3. Put a shallow container beneath water shut-off valve (at wall) and water line
connection at tank to catch excess water.
4. Disconnect water line from cut-off valve.
5. Clean and dry fittings and threads.
Remove toilet seat and clean mounting area.
(See “G. Troubleshooting”
for help.)
Save seat mounting parts to re-use.
After applying Teflon tape to its threads, attach the nipple and hose (Parts no.
2003.16 and 2003.14) and tighten.
Determine if your toilet is a one-piece or two-piece unit. If you have a
one-piece unit please follow instructions on changing bushing bracket
(Part no. 2003.09) mounting location on “Parts Breakdown” page
before continuing.
Insert threaded bushing of support bracket (Part no. 2003.09) into toilet
bowl screw opening used for mounting toilet seat. Use opening on your
left when facing the toilet tank. Secure to toilet by installing rubber washer
first, followed by plastic washer and chrome nut, onto bottom of threaded
bushing. Finger tighten only.
A. Disconnecting your toilet’s water supply line
B. Installing your bidet
2
This unit can accommodate hot and/or cold water installations. For cold
water only, install as directed. For hot water installation, please use the Hot Water
Installation Kit (Part no. 2003HIK ), available by calling 1-800-681-0753.
Use Teflon tape
on
all connections.
Your
GoBidet™
will attach to a one-piece toilet (tank/bowl are molded into one
piece) or a two-piece toilet (tank/bowl are separate). It also fits regular (round)
or elongated toilets. See “Parts Breakdown”page for instructions on changing
the bushing bracket mounting location.
Before tightening bushing completely, move shower arm (Part no. 2003.01)
to its maximum extension, moving the support bracket (Part no. 2003.09)
until shower head is in center of toilet. Upon retraction, shower arm should
rest beneath rim of toilet. Finish tightening bracket in place.
DO NOT OVER-TIGHTEN BUSHING OR TOILET WILL CRACK.
1.
2.
3.
4.
5.
