56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — ST1520E-S
10
EN
DESCRIPTION
KNOW YOUR LINE TRIMMER (Fig. A)
1. Rear Handle
2. Switch Trigger
3. Lock-off Button
4. Adjustable Front-assist Handle
5. Soft Sleeve
6. Hinge
7. Shaft
8. Guard
9. Battery-release Button
10. Latch
11. Electric Contacts
12. Ejection Mechanism
13. Trimmer Head (Bump Head)
14. Line-loading Button
15. Cutting line
16. Release Tab
17. Line-cutting Blade
18. Hexagon Wrench
ASSEMBLY
WARNING:
If any parts are damaged or missing,
do not operate this product until the parts are replaced.
Use of this product with damaged or missing parts could
result in serious personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended for use with
this Line trimmer. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
To prevent accidental starting that could
cause serious personal injury, always remove the battery
pack from the tool when assembling parts.
UNFOLDING THE SHAFT
WARNING:
In order to avoid pinching your hands or
fingers, do not hold the shaft at the joint.
WARNING:
Do not attempt to start the line trimmer
until the shaft has been locked.
Put your line trimmer on the ground or the floor and
make sure that the cable is inside the shaft, so that it will
not be pinched when closing the joints. Carefully unfold
the shaft until the two holes in the joint are accurately
aligned (Fig. B).
Insert the bolt (supplied) and tighten it with the supplied
hex wrench to lock the shaft in place (Fig. C).
MOUNTING THE GUARD
WARNING:
Always wear gloves when mounting or
replacing the guard. Take care of the blade on the guard
and protect your hand from cutting.
WARNING:
Never operate the tool without the
guard firmly in place. The guard must always be on the
tool to protect the user! When the guard is fixed, never
attempt to remove or adjust the guard, if a replacement
is needed, it should be performed by a qualified service
technician!
Align the two bolts, which are pre-assembled on the guard,
with the two screw holes in the shaft (Fig. D), and then
tighten them with the supplied hex wrench(Fig. E).
Make sure the guard is fixed according to Fig. D & E, any
reverse fixing will cause great danger!
MOUNTING AND ADJUSTING THE FRONT-ASSIST
HANDLE
1. Loosen the four screws in the handle with the
supplied hex wrench and remove the screws and the
lower clamp from the front-assist handle (Fig. F).
2. Attach the front-assist handle and the lower clamp
onto the shaft and secure them by pre-tightening the
four screws. Turn the front-assist handle upward so that
it points toward the top of the rear handle (Fig. G).
3. Adjust the front-assist handle position so that it is
between the soft sleeve and the hinge, as shown in
Fig. H.
NOTICE:
The handle should be adjusted so that your front
arm will be straight when using the trimmer.
4. Use the supplied hex wrench to tighten the four
screws so that the handle cannot be rotated on the
shaft.
WARNING:
Only fix the front-assist handle between
the soft sleeve and the hinge.
WARNING:
The tool can not be used without the
front-assist handle securely fixed.
