Go Power! TS Kit
Owner’s Manual
3
3. Installation
1. Ensure the shore power plug is not connected to shore power and batteries are disconnected.
2. Connect the RV shore power cord to transfer switch input: wires are labeled “Shore Hot” and
“Shore Neut”. Connect ground wire to provided ground bonding block.
3. Connect transfer switch output to AC power panel. (Use terminals labeled “AC Panel”).
4. Plug supplied inverter power cord into inverter. (With inverter power switch off or disconnect
inverter from the battery.)
5. Plug battery charger into transfer switch and connect to batteries.
6. Disable converter.
3.1 Installation Diagram
Please see Figure 1 for additional wiring information.
4. Disclaimer of Liability & Warranty
The conditions or methods of installation, operation, use and maintenance of this kit and its solar
module are beyond the control of Go Power! does not assume responsibility and expressly
disclaims liability for loss, damage, or expense arising from, or in any way connected with such
installation, operation, use, or maintenance.
Go Power! Inc does not cover labour or shipping
for items returned.
GP Inverter
Disconnect
Shore
Power
GP Battery
Charger
AC
Panel
To Batteries
Transfer
Switch
Converter
