8
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1. Screwing depth stop
2. Depth setting ring
3. Speed
controller
4. Operating
switch
5. Locking
button
6. Changeover
switch
7. Chuck
3. Proper use
The screwdriver is designed for the screw-fitting of
plasterboard and particleboard panels in the dry
section sector.
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains voltage:
230 V~ 50 Hz
Power input:
720 W
Idling speed:
0 – 2200 rpm
Tool holder
6.35 mm hex
Protection class:
II /
쓑
Weight: 2.0
kg
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level
68.9 dB(A)
K
pA
uncertainty 3
dB
L
WA
sound power level
79.9 dB(A)
K
WA
uncertainty 3
dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Screwing without hammer action
Vibration emission value a
h
≤ 2,5 m/s
2
K uncertainty = 1.5 m/s
2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating
plate are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Only ever use screw gun bits which are suitable
for the purpose and in faultless condition.
Before you begin to screw in walls and masonry,
check for concealed electric wiring, gas pipes
and water pipes.
The screw gun is equipped with a claw coupling.
The spindle does not start to rotate until the
screw is pushed into the workpiece.
Anleitung P1L-DB-6_SPK7:_ 11.07.2008 10:40 Uhr Seite 8
