All contents are Copyright © 2013 Go Net Systems Ltd. All rights reserved.
Document#
GoBeam8000 Quick Configuration Guide
All contents are Copyright © 2013 GO Net Systems Ltd. All rights reserved.
Document#
GoBeam 5100/6100 Quick Configuration Guide
Page 1
UM000004 Rev. 1.0
Page 4
NOTE:
For more information on the different type of radio interfaces your device contains
and the interface numbers for the access radio interfaces see the Radio Interfaces
table.
Example:
/configure ssid 3 name GO-WLS2 vlan 7 privacy-method wpa
type hidden
/configure privacy wpa ssid 3 passphrase 12345678 Management
key-mngmnt psk
/configure interface Dot11Radio 0 ssid 3 add
copy running-config startup-config
7. Configure access to the device
The following steps configure the access to the device:
a. Disable access to the device using an unsecured Telnet protocol:
/configure ip telnet disable
b. Add a user with a password to access the device:
/configure username
<username string>
password
<password string>
privilege
{super | admin | viewer}
c. Set a hostname and prompt to be unique for each device:
/configure system hostname
<prompt string>
d. Save the configuration:
copy running-config startup-config
Example:
/configure ip telnet disable
/configure username Paul password GoNetSystems privilege super
/configure system hostname Gateway1
copy running-config startup-config
8. Select Access Channel
The following steps are used to select and define the access radio channel:
a. Scan all access channels and gather data for channel selection
(A site survey takes approximately 10 minutes):
/configure sitesurvey start spectrum 2.4G auto-channel-selection
{ enable |
disable }
b. Display the results of the site survey:
show sitesurvey
c. Set the access radio channel based on the best grade identified by the site survey
(grade values for the adjacent channels are critical when selecting a channel):
/configure interface Dot11Radio
<interface number>
channel
<channel number>
d. Save the configuration:
copy running-config startup-config
