GO Elliptical T-300PX, User Manual

Page: 19 / 40

- 19 -
STEP 7 : Roller Alignment
(A) check with both Alum Rail there are Two of soft PP Bars attach to each
side of each Rail .Set both PU roller To the center of each the soft pp bars
in case any of the Roller will not be able to total set to the center of the
Rails Simply as photo 3 shown hold both of the handlebars (#72 and #73 )
as photo shown move both habdlebars together from side to Side to
make sure the Roller are set in the center of the alignment PP bars with
ease . if not, check with the Screws that suppose to Tightened with finger
tighten if some are tightened too much With assembly steps 3, 4, and
7 , (if not loose them a little ) Make sure all screws are in loose condition
and the Roller Will be set in the center of the pp Bars with ease After
Roller set then tighten up all screws ( #18) in Step 3, 4, and 7, firmly Also
the long Screw (M8 X 90 mm + nut ) tightened up as well.
(B) after all screws tightened up and PU Roller well set , take pill off all four
soft PP bars at both side of each PU Roller Will not need these soft PP
bars anymore
1 2
3
4 5 6