Gnom SUPER, Operator'S Manual, Page: 8 / 30

V10/2015
8
USER’S MANUAL FOR OPERATION
# To move vehicle Forward/Back and turn Right/Left use right joystick. You can adjust speed
gradually (128 grades) pressing the joystick. The direction and speed are indicated on an overlay.
# To move vehicle Up/Down use left joystick. Also press left joystick to adjust the Jump mode.
# Slow mode (SLOW). Press right joystick and adjust power gradually (50%, 75%, 100%).
# Simultaneously press X(3)+ R1 to change the intensity of the front lights ( LOOP : 0%

100%, 100%  . If press X(3)+R1+ R2 simultaneously 100% brightness turns on.
( Simultaneously press X(3)+ R2 adjust rear lighters – if it is mounted )
# Control
the GRABBER (if this is part of device) by keys R1/R2
# To tilt cam Up/Down press L1/L2 pads. If press L1+L2 simultaneously camera goes to the
median position.
# Jump mode allows to push vehicle slightly for a distance 30 – 50 cm them stop. To chose the
jump direction press arrows (Left/Right, Up/Down). To adjust the jump power use left joystick.
# By key SELECT switch - active forward/back camera
# By keys X(3) switch-on/switch off laser
# Autodepth mode. Press key ▲(1) to fix the vehicle at the depth you needTo change the depth
use left joystick. Autodepth mode and depth are indicated on an overlay.
# Autoheading controls ON/OFF from the «Start» key (version: left joystick to left – ON, to right
OFF ). You should select forward speed then switch ON autoheading. Autoheading mode holds the
speed and direction.
# You can choose the menu language (Russian/English)
5. Finishing the operation
To finish the operation switch power OFF then disconnect cables and pull into the reel.
Try to avoid nods and twisting of the cable.
After operation please clean propellers and shafts of motors and wash the vehicle in fresh
water.
WARNING !!!
Special Functions
Sleeping mode (Power Saving Mode)
In order to save power and lengthen the using life of batteries, a power saving system is designed in
the wireless joystick. The joystick turns into sleeping mode (power saving mode) under the
following conditions:
A. If there is no operation within 30 seconds since the connection between the controller and the
receiver, the controller will turn into sleeping mode (power saving mode).
B. There is operation since the connection between the controller and receiver. If there is no
operation for 5 minutes, the controller will turn into sleeping mode (power saving mode).
Press
【
HOME
】
button can stop this sleeping mode (power saving mode).