18
Installation Instructions for the Built
-
in and Slot
-
in fixings of
GN Espace ovens and cookers (all models)
Installation for Fixed Installation (Boat, Motor
-
Home, Caravan)
A ventilation gap of at least 30mm must be provided at the back edge of the oven.
A minimum gap of 3mm on either side of the unit is required and the material in the cavity should be a non
-
combustible such as sheet metal.
The adjacent materials must be non combustible and able to resist temperatures of at least 100 Celsius
The appliance is designed to be mounted and held safely in place by means of a set of runners on the base of the
oven which are specifically designed to slide onto a matching set of runners fixed to the base of the furniture cavity.
Once slid in position the oven is secured by means of two screws at the front of the sliders.
The unit is not designed to have a cover placed over it, and will cause a hazard if the unit is covered.
The diagram above shows the drill locations for the runners (shown right) on the cabinet base which is common
to the Levante, OceanChef and OceanChef XL models.
Remote location of the 1.5V ignition battery holder
For models intended for build
-
in installation, the battery holder and battery are supplied as loose component
when the cooker is delivered.
Position the battery holder in an accessible location within reach of the cable. This may require feeding the cable
through a drilled hole into the adjacent cupboard.
Ensure that the cable is protected from chaffing. Use screws to fix the battery holder firmly in place.
Connect the cable to the battery holder using the push connections. The battery holder is connected to the appli-
ance using the supplied electrical cable.
The battery (1.5V AA size) is located in the housing. When you need to replace the battery unscrew the battery
cover by hand, change the battery and replace the lid. Make sure that the –ve end of the battery is held in the
spring.
Summary of Contents for G1007G
Page 19: ...19 NOTES ...