21
Fig. 36
Fig. 37
Fig. 38
TIPS FOR USING THE REAR
ROLLERS (Figure 37)
1. If the front rollers are heated,
you may perform certain
applications from the rear
operating position of the
laminator.
2. Ensure the chill idler is in the rest
position if using boards.
3. Ensure the safety shield is
located in the rear position.
4. Ensure the REAR CONTROLS
have been enabled.
5. You may perform mounting
applications, pre-coating
applications and single side
applications from the rear of the
machine.
TIPS FOR MOUNTING PRE-
COATED BOARDS (Figure 38)
1. Load the laminator as illustrated
in Figure 38.
2. Ensure the chill idler is in the rest
position.
3. Ensure the chill idler is removed,
the rear slitter is to one side and
the inline slitters are not
obstructing the path of the
boards.
4. Heat, 125
O
F (52
O
C), may assist
the process and increase output
quality.
5. Do not stop once you have
started the mounting process
through the machine.
APPLICATIONS
TIPS FOR PRE-COATING BOARDS
(Figure 36)
1. Load the laminator as illustrated
in Figure 36.
2. Ensure the chill idler is in the rest
position.
3. Set the roller pressure handle to
the correct thickness.
4. The width of the roll should not
exceed the width of the board
by more than 1/2 in. (1.3 cm).
5. Use a leader board to start the
run and a trailer board to finish
the run.
6. Using the pull rollers will allow
you to leave gaps between
boards.
7. If not using the pull rollers, have
the boards nearby to butt end to
end during feeding.
Mount
adhesive
Leader board
Trailer board
Board
Pre-coated board
Image
Release liner