TBE-D5001-TRI-xxx
- SIL 3 HART® multiplexing Termination Board for Tricon & Tricon CX systems
G.M. International ISM0579-0
3
DIN-Rail clip installation on termination board enclosure
For termination board with 2 x Plastic DIN-Rail clips TBE-FIX-PL-001, extract each clip and related instruction sheet from plastic bag. Follow the instruction sheet and the following
figures to change lever position (from default to specific for TBE-D5001-TRI-xxx) on each clip:
Default position
Instruction sheet
Changing lever position
Specific position for
TBE-D5001-TRI-xxx
For the termination boards
TBE-D5001-TRI-xxx
, place the enclosure as shown in the following figures and fix each Plastic or Metal DIN-Rail clip to enclosure by 2 x M3 (10 mm) screws
included on TBE-FIX set:
With 2 x Plastic DIN-Rail clips TBE-FIX-PL-001
With 2 x Metal DIN-Rail clips TBE-FIX-MT-002
On TBE enclosure must be installed 2 DIN-Rail clips to be chosen between two possible versions: TBE-FIX-PL-001 (Plastic) or TBE-FIX-MT-002 (Metal).
On TBE order, customer can add TBE-MNT-001 code (for each DIN-Rail clip) to request DIN-Rail clip factory mounting. Otherwise, customer follows DIN-Rail clip installation procedure.
TBE with Conformal Coating
On TBE order, customer can add the following code to request Conformal Coating applied on TBE by factory process:
TBE-CTG-001 code for TBE-D5001-TRI-xxx.
