TX7200
Instruction Manual
Page 3
To Remove Battery Pack
To Refit Battery Pack
Slide upwards
Swing away
Press
Press
your TX7200 is supplied with a 7 .2 Volt 1200 mah ni-MH
rechargeable battery pack . When the battery is new, it must
be fully charged before being used for the first time . If left
unused your TX7200’s battery pack will discharge itself
within a few months . If you have not used your TX7200
for some time, you will need to recharge the battery pack
before use .
The battery pack is a sealed unit . There are no user
serviceable parts inside .
WARNING:
use only GMe electrophone approved battery
packs and chargers . The use of other types may be
dangerous and will void the warranty .
Removing the Battery Pack
The battery pack is a self contained unit which can be
removed from the radio as follows:
1 . Hold the radio face down in one hand .
2 . With the thumb of one hand, push the locking tab
upwards towards the top of the radio while swinging the
top half of the battery pack away from the radio with the
other hand .
3 . once clear of the locking tab, lift the battery upwards
away from the radio . The base of the battery pack is
retained in a slot in the metal frame at the base of
the radio .
Re-fitting the Battery Pack
1 . carefully position the tongue in the base of the battery
pack into the slot in the metal frame at the base of
the radio .
2 . Swing the top half of the battery pack into place against
the radio .
3 . using both thumbs (one each side of the belt clip) press
the top half of the battery firmly onto the radio until the
locking tab clicks downward locking the battery pack
into place .
Charging the Battery Pack
your TX7200 should be charged using the Bcd001 rapid
charger . The Bcd001 rapid charger can recharge the
battery pack in around 1 hour . For further information on
charging your battery and tips on conserving battery power,
see section on 'Maintaining your Battery Pack' on page 6 .
GETTING STARTED
