Black plate (33,1)
GMC Yukon Denali/Yukon XL Denali Owner Manual - 2012 - CRC 2nd
Edition - 11/9/11
Vehicle Care
10-33
To adjust the vertical aim:
1. Open the hood. See
2. Locate the aim dot on the lens of
the low
‐
beam headlamp.
3. Record the distance from the
ground to the aim dot on the
low
‐
beam headlamp.
4. At a wall, measure from the
ground upward (A) to the
recorded distance from
Step 3 and mark it.
5. Draw or tape a horizontal line (B)
on the wall the width of the
vehicle at the height of the mark
in Step 4.
Notice:
Do not cover a headlamp
to improve beam cut-off when
aiming. Covering a headlamp may
cause excessive heat build-up
which may cause damage to the
headlamp.
6. Turn on the low-beam
headlamps and place a piece of
cardboard or equivalent in front
of the headlamp not being
adjusted. This allows only the
beam of light from the headlamp
being adjusted to be seen on the
flat surface.
7. Locate the vertical headlamp
aiming screws, which are under
the hood near each headlamp
assembly.
The adjustment screw can be
turned with an E8 Torx
®
socket.
