![background image](http://html.mh-extra.com/html/gmc/vec158-au/vec158-au_instruction-manual_2235901011.webp)
11
Replacing the
spotlight
To replace the H3 type 12
volt bulb, you will need a
small Phillips type
screwdriver and a
replacement bulb (GMC
Part VEC120-AUBUL).
Bulb life can be shortened
by installing a bulb with dirt or fingerprints on it.
The bulb can be wiped clean with a cloth moistened with alcohol.
During bulb installation, avoid touching the glass part of the bulb.
1. Disconnect the unit from any charging adapters.
2. Pull the rubber bezel away from the front of the spotlight to
reveal two small Phillips screws in the wide retaining ring.
The screws are on opposite sides of the ring (fig. F).
3. Using the screwdriver, remove (counter-clockwise) the two
screws and set them aside (fig. G).
4. Lift off the retaining ring, glass lens and rubber “O” ring and set
them aside (fig. H & I).
5. Carefully remove the reflector and bulb assembly (fig. J).
6. On the failed bulb, disconnect the bulb wire from the red
power wire.
7. Unsnap the hairpin retaining wires from the reflector’s
flange (fig.K).
8. Using the screwdriver, loosen the retaining screw to remove
the bulb from the reflector (no need to completely remove this
screw) (fig. L).
9. Lift out the bulb and the
attached wire (fig. M).
F
G
I
H
J
L
K
M