11
2. Secure the height adjustment knob by tightening the
Phillips head screw (Fig. J).
I
J
3. Fit the height adjustment handle onto the shaft ensuring
that the flat on the handle locates onto the flat at the front
of the shaft (Fig. K).
4. Secure the height adjustment handle by tightening the
Phillips head screw (Fig. L).
K
L
Fitting the riving knife
1. Remove the 8 screws securing the table insert and take
off the table insert (Fig. M).
2. Loosen the height adjustment locking knob and turn the
blade height adjustment handle to raise the blade to its
highest position (Fig. N).
M
N
3. Tighten the height adjustment locking knob.
4. Using the hex key provided, loosen the two hex bolts on
the riving knife clamp and insert the riving knife between
the two metal plates that form this clamp (Fig. O).
5. Adjust the position of the riving knife so that the gap between
the knife and the teeth of the blade is even along the
curve of the blade and is not less than 5mm wide (Fig. P).
O
P
6. Tighten the 2 hex screws to secure the riving knife in position.
7. Replace the table insert and secure using the 8 screws.
Fitting the blade guard
1. Remove the hex nut and
washer on the side of the
guard (Fig. Q).
2. Remove the screw from
within the guard.
3. Place the blade guard over the
riving knife so that the hole in
the guard and the hole in the riving knife are aligned (Fig. R).
4. Insert the screw through the hole and secure using the
nut and flat washer (Fig. S).
R
S
Q
