12
1. Loosen the screw under the table by rotating it in an
anti-clockwise direction.
2. Tilt the table to the desired angle as indicated on the
bevel scale.
3. Tighten the screw under the table by rotating it in a
clockwise direction.
Note.
When the table is tilted the work piece should be
clamped to the table.
Extension tables
Caution.
Always ensure that the drill press is switched
off and the plug is removed from the power point before
making any adjustments.
1. The extension tables are handy when working with larger
work pieces and allow the table size to be increased for
greater material support.
2. To adjust the extension table loosen the 2 knobs on the
underside of the work table.
3. Extend the extension table to the desired width.
4. Tighten the 2 knobs to secure the extension table in
position.
Installing and removing drill bits
Caution.
Always ensure that the drill press is switched
off and the plug is removed from the power point before
making any adjustments.
1. Loosen the chuck sufficiently so that the jaws are open
wide enough to allow a bit to be inserted. The chuck is
loosened by rotating the collar in a clockwise direction.
2. Place the bit into the open chuck as far as it will go.
3. Tighten the chuck by rotating the collar in an anti-
clockwise direction.
4. To remove the bit, loosen the chuck by rotating the
collar in a clockwise direction.
Setting the drilling depth
Caution.
Always ensure that the drill press is switched
off and the plug is removed from the power point before
making any adjustments.
1. Loosen the handle screw half
a turn using 6mm hex key
2. Ensuring the drill bit is tight
in the chuck use the feed
wheel to lower the spindle
until the drill bit just touches
the work piece.
3. Holding the handle in that
position rotate the depth
scale to the desired drilling depth.
4. Tighten the handle screw firmly to secure the handle in
position.
