10
LED Work area light
The drill has 3 LED lights (11)
to illuminate the work area and
improve vision when drilling in
areas with insufficient light.
To turn the LED lights on and
off depress the LED light switch
(13).
Using the drill
Use the forward/reverse switch (4) to select the direction
of rotation, then pull the trigger (3). This trigger switch is
an electronic variable speed control which enables the user
to vary the speed continuously. The speed varies according
to how far the trigger switch is depressed, the further it is
depressed the faster the chuck will rotate and the lighter it
is depressed, the slower it will rotate.
To stop the drill, release the trigger switch.
Note.
You can only change the direction of rotation of the
drill using the forward/reverse switch when the trigger is
NOT depressed.
Forward/reverse switch
This switch (4) will allow you
to change the direction of
the motor while the trigger
switch is not depressed.
Drilling uses the forward mode.
The reverse mode is intended for
the removal of screws.
Drilling positions
This symbol indicates the DRILLING MODE. Used for
all normal drilling (Wood, Aluminium, and Steel) in
this mode the clutch is deactivated.
This symbol indicates the HAMMER MODE. This mode
will activate hammer action, whilst drilling. For best
results in hammer mode, set the gear selector to
high gear.
Torque adjustment/hammer selection collar
By rotating the torque adjustment/hammer selection collar
(2) behind the chuck, it is possible to adjust the torque to
each of nineteen settings, or select hammer action or the
drill setting.
The range of nineteen torque settings allows better control
when using the drill as a screwdriver as it prevents over-
tightening of the screws.
The symbols circling the collar are used to indicate the
level of torque. The larger the symbol on the collar, the
higher torque and the larger the fastener which can be
driven. To select any of the symbols, rotate the collar
(2) until the desired symbol aligns with the arrow head
indicator on the housing.
2 Speed gearbox
The 2 Speed Gearbox allows
you to select a gear with the
optimum speed and torque to
suit the application.
Note.
When changing the gear
selector ensure the drill is not
operating.
1. To select the LOW gear (low speed, high torque setting),
push the gear selector (9) forward, towards the chuck.
The word LOW will be displayed.
2. To select the HIGH gear (high speed, low torque
setting), push the gear selector (9) back, away from the
chuck. The word HIGH will be displayed.