3- Adjusting the cut
I.
Adjusting the Warner clutch.
First make sure the Warner clutch is set to is start position, where the pal is placed on the
counterpart.
NOTE: Keep the clutch free of grease and oil, as this can be a cause of malfunction.
II.
Adjust the camshaft.
Adjust the camshaft so the knife is placed in top position. This is done by loosening the two bolts as
shown on the picture. When knife is in top position the bolts are tightened again.
III.
Adjust the outer ring.
Adjust the outer ring so it activates the sensor, the sensor will light up when activated.
