11
NOTE:
Edging of heavily overgrown edges and damp soils
can create greater build-up of difficult to remove waste. It
may be necessary to remove the bulk of this material using
a long thin implement (ie. screwdriver) before operating the
guard cleaner.
Maintenance
Changing the Blade
WARNING:
Before performing any maintenance or tool
adjustments ensure the power supply cable has been totally
disconnected from the mains power.
1. Lay the edger on its side with the blade facing up.
2. Place a 26mm spanner over the outer blade flange and
use a 17mm spanner to remove the lock nut in an anti-
clockwise direction.
Remove the lock nut, outer flange and the blade and
ensure the shaft and inner flange are clean of any
dirt, etc.
3. Fit the new blade and outer flange and ensure all is
located correctly, as shown. Fit the lock nut and tighten
firmly using both spanners.
4. After the blade is secure, rotate the blade by hand to ensure the
blade is not making contact with any components of the edger.
Blade wear is expected whenever you use your edger.
Blades wear quite quickly when edging along concrete
paths. This does not effect the efficiency of the edger
and is expected due to the aggressive abrasion of
concrete on steel.
Edger Blades are not a warranty item! Edger Blades
are available from your local Hardware store or can be
purchased direct from GMC. See details on the back page
of this manual.
Before performing any maintenance or tool adjustments
ensure the power supply cable has been totally
disconnected from the mains power.
Cleaning
CAUTION.
Use only mild soap and a damp cloth to clean
the tool.
Never allow any liquid to get inside the tool, never immerse
any part of the tool into a liquid.
Preventing Corrosion
Fertilizers and other garden chemicals contain agents that
greatly accelerate the corrosion of metals. If you use the
tool in areas where fertilizers or chemicals have been used,
the tool should be cleaned immediately afterwards. Wipe
all exposed parts with a damp cloth. You may lubricate only
metal parts with a light petroleum based oil. When cleaning,
never immerse in water or squirt it with a hose.
General inspection
Regularly check that all the fixing screws are tight. They
may vibrate loose over time.
Repairs
Only an authorised service centre should replace the
cordset or effect other repairs. If the cordset is damaged
or worn, have it repaired or replaced by an authorised
service centre.
