M
Q1
Tire Rotation
To equalize wear it is recommended
that the tires be rotated every 6,000
miles.
Upon rotation, tire pressure
must be adjusted (front and rear) in
accordance with the recommendations
in the tire infiation pressure table.
Changing Tires
CAUTION:
block the
position.
Remove hub cap or wheel cover with
Hat end of lug nut wrench and loosen
wheel nuts slightly. Set lever on jack
to UP position.
Properly position load rest which
engages bumper by moving base of
jack slightly under car and engage
tang of bracket i.n bumper notch, then
bring jack base back toward upright
position. Check that load rest is posi-
tioned before operating jack. NOTE:
Base of jack column should be slightly
angled in toward
car since
it will
straighten as car is raised.
mm
nm
mm
nm
film
nu
mm
Mlm
5 WHEELS
4 W HEELS
CHEVELLE
POSITION JACK IN
BUMPER NOTCH
NOVA
FRONT
REAR
|
osmoN JACK UNDER BUMPER
JUST OUTBOARD OF BOLTS
82
Jack Operation
After jack is positioned as noted
above, use wheel nut wrench as jack
handle and raise car until tire clears
ground.
Remove
wheel
nuts and
wheel, install spare and tighten wheel
nuts. Move jack lever to DOWN and
install hub cap or wheel covet.
CAUTION'
car
when it is supported
use safety sfands
fhe
car if necessary to
a Positraction
since
CAMARO
POSITION JACK
IN BUMPER NOTCH
9
0
FRONT
REAR
Summary of Contents for Chevrolet CAMARO 1969
