3.
Connect factory 10-pin plug (See
Fig. 2
) to harness 10-pin socket
(white) (
See Fig. 4)
Fig. 3
10-pin plug
Fig. 4
10-pin socket
4.
Connect harness 10-pin plug (black) (See
Fig. 3
) to CD changer 10-pin
socket (See
Fig. 5
)
Fig. 5
10-pin socket/10-pin plug
5.
Connect/Tap installation harness red wire to 12V ACC (Accessory)
supply in vehicle. Accessory supply available when ignition key is in ACC
position or beyond. Avoid connecting red wire to battery supply (always
on).
Noteworthy
: If streaming is interrupted when headlights, wipers,
defroster, A/C; the 12V circuit used to power module is drown down by
these accessories.
To resolve find an alternate 12V ACC circuit to
power module.
Also, on rare instances if smart device volume is set
too high, it will “clip” and module will un-pair/pair intermittently.
To
resolve, lower volume on audio device.
6.
Tuck and secure any extra wires away from moving parts and
proceed
to “Pairing”
Pairing
Pairing process varies among devices but the process is the same. These steps
are done upon initial install and will not have to be repeated. Bluetooth range is
approximately 30 ft. (ensure smart device is within range).
1.
Turn Ignition and radio “ON”
Green LED will flash (pairing mode)
2.
On A2DP device: Go to
Settings, Wireless & Networks, Bluetooth
Settings
3.
Select
Bluetooth
and turn on
4.
Tap
Scan (Search) for devices
.
5.
Wait for Bluetooth device name (See below) to appear and select it.
Green LED inside module peephole will glow steady (paired)