INSTALLATION INSTRUCTIONS
SHEET OF
PART NO.
84233234
AUTH
DR
DATE
REVISION
ALL INFORMATION WITHIN
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
SHEET OF
84233234
PART NO.
TITLE
Rear Seat Mudder Cover
REV 15FE17
Rear Seat Mudder Cover
2
2
9
9
3. Route center seatbelt through the cover opening at the top of the seat cover. Attach Velcro (Hook) on the backrest of the cover
to the seat back. Fold the seat down to adjust and secure backrest cover. Tuck cover under headrest guides.
4. With the seat partially folded, push the Velcro strip and the three (3) female buckles/straps in between the backrest and cushion.
Use the tabs connected to secure Velcro to rear seat carpet after removing the protective felt strips. Before locking the seat back
into the upright position, ensure that the child seat anchors are aligned and visible with the plastic baby dot buttons centered
with the childseat anchers.
5. Once the backrest is secured and adjusted into position pull the bottom cushion cover over the front of the seat. Push the two
(2) “J” hooks nearest the center seat belt through under the seat and connect to seat frame. Connect the remaining six (6) “J”
hooks on the cover to the corresponding locations on the seat frame. Attached the nylon straps with the male buckles (3) to the
female buckle (3) underneath the seat. Tighten the nylon straps after buckles have all been connected
22AU16 Initial Release - Gino LeDonne
2585499
15FE17
Revision - Gino LeDonne
2618359
