10
battery indicator is showing only 1 LED (low) the battery
should be removed and put on the charger.
LED Work area light
The drill has 3 LED lights (11)
to illuminate the work area and
improve vision when drilling in
areas with insufficient light.
To turn the LED lights on and
off depress the LED light switch
(13).
Using the drill
Use the forward/reverse switch (4) to select the direction
of rotation, then pull the trigger (3). This trigger switch is
an electronic variable speed control which enables the user
to vary the speed continuously. The speed varies according
to how far the trigger switch is depressed, the further it is
depressed the faster the chuck will rotate and the lighter it
is depressed, the slower it will rotate.
To stop the drill, release the trigger switch.
Note.
You can only change the direction of rotation of the
drill using the forward/reverse
switch when the trigger is NOT
depressed.
Forward/reverse switch
This switch (4) will allow you
to change the direction of
the motor while the trigger
switch is not depressed.
Drilling uses the forward mode. The reverse mode is
intended for the removal of screws.
Adjustable torque
This drill is equipped with 20
torque settings plus one drill
setting which are controlled
by the torque collar (2). By
rotating the collar behind the
chuck, it is possible to adjust
the torque.
This will allow better control
when using the drill as a
screwdriver as it prevents over-tightening of the screws.
For drilling, always use the use the Drill position by
aligning the Drill symbol with the triangular indicator on
the front face of the drill near the torque collar.
For setting the torque position, select a low setting on
the torque collar and align the selected symbol with
the triangular indicator on the top of the drill. Increase
gradually to set the correct torque. It is better to use a
scrap piece of material if possible to set the torque.
Inserting and removing bits
This drill has a keyless chuck, which means that a chuck
key is not needed to secure a bit in the drill.
1. Open the chuck by holding
the rear section of the chuck
firm and rotating the front
section in a anti-clockwise
direction, sufficiently enough
to allow the drill bit required
to fully enter the jaws of the
chuck.
2. Ensure the drill bit is fully
inserted, so that the chuck
jaws grip the straight section of the bit.
3. Holding the rear section of the chuck firmly, rotate the
front section of the chuck clock-wise until the jaws
