Cutting Tape
LED tape is unique in the fact that it is the only
lighting ‘fixture’ that you can cut to length with
only a pair of scissors. We made it easy for you to
do that! Find the cut mark closest to your desired
length and cut cleanly, across the marks.
Fig. 1
Peel back adhesive 1/2” to expose back of tape.
You are now ready for attaching a connector
Fig. 2.
If you’re at the end of your run, you’re done.
Attaching Tape to Controller
and Power Supply
Connect three wires from tape to three terminals on
SHWC-CCT controller.
Fig. 3.
Connect leads from LineDRIVE 24VDC non-dimming
driver to terminals on SHWC-CCT controller.
Fig. 4.
Note that controller can be manually switched on
and off via the two-position power switch located
near the 24VDC power terminals.
LTR-S-TUNtapeINST
PAGE 2
LEDTask™ Flexible LED Tape
LTR-S Series
Dry Location CCT Tunable LED Tape
Cut on mark
Fig. 1
1/2”
Expose back of
strip before
connecting
Fig. 2
Fig. 3
Fig. 4
LineDRIVE 24VDC
Non-Dimming Power
Supply
Pairing Before Mounting
Whenever possible, it’s important to be close to
your WiFi source when pairing a LUXcontrol device.
Fig. 5.
This is true for any device that depends on
a WiFi signal. Consult the pairing directions that
comes with the controller, or watch our LUXcontrol
pairing video.
®
SHWC-CCT
12/24V Low Voltage CCT
Smart Home WiFi Controller
Input Voltage:
12 to 24 VDC
Load Current:
Max 10A, 5A per channel
Load Power:
Max 120W @ 12V
Max 200W @ 24V
DC OUTPUT:
INPUT:
+
W
C
DC+
DC−
tc
90°C Max.
Connection:
Stripping length: 6 ~ 7 mm
Wire gauge range: #12 ~ #18 AWG
Apply 90'C or above temperature rating wire
CAUTION - Risk of Electric Shock
ATTENTION - Risque de choc électrique
Dry and damp location use only
WiFi Standard:
IEEE 802.11b/g/n
RF Frequency:
2.4GHz
OFF
ON
Made in China
Fig. 5
Bring controller in close prox-
imity to WiFi source (modem
or router) during pairing.
®
