4
Press the Selector Button on the Colour Light Controller to select among:
(1) CLEAR-MULTI FADING
(2) CLEAR-MULTI FLASHING
(3) CLEAR-MULTI ALTERNATING
(4) STEADY CLEAR
(5) FLASHING CLEAR
(6) STEADY MULTI
(7) FLASHING MULTI
(8) COMBINATION
(9) OFF
WARNING
1. To reduce the risk of fire and electric shock:
a) Use only the power supply that was provided with this product;
b) Do not install on trees having needles, leaves or branch covering of metal or materials which look like metal;
c) Do not mount or support strings in a manner that can cut or damage wire insulation.
2. Use only the adaptor supplied with this product.
Using a different adaptor will damage the lights and may cause fire, or electrical shock hazards.
3. For Indoor Use Only.
4. The external flexible cable or cord of this tree cannot be replaced. If the cord is damaged, the luminaire should be destroyed.
MODEL #: TG76M4I88D00
1. Remove all ornaments and decorations. For pre-lit trees, first unplug extension cord from the wall outlet and then
disconnect light extension cord between each section of the tree.
2. Disassemble the tree from the top to the bottom. Start with the tree top and gently lift up to remove it from the
section below and fold all branches toward the pole.
3. In case of difficulty separating the tree pole (trunk), apply a small amount of lubricant at the joint and rotate the
upper pole in both directions. Lift up the upper pole again.
4. Continue by gently lifting each section(s) from the section below and fold all branches toward the pole until the
bottom section is removed from the tree stand.
5. Carefully place all tree sections into the shipping box and tape it shut.
6. When not in use, please store your tree in a cool, dry place away from sunlight. Exposing your tree to excessive
heat or humidity may damage your tree.
STORAGE INSTRUCTIONS
TROUBLE SHOOTING TIPS
Each tree includes hinge pins/washers. 12 spare bulbs are included for pre-lit trees.
If extra parts are needed, please contact our customer service center at: 1-800-521-2364
SPARE PARTS
HOW TO USE THE DUAL COLOUR LIGHT CONTROLLER:
Colour Light Controller
Selector Button
Fig. D
For Pre-lit Trees, If The Tree Does Not Illuminate
1. Please check to make sure that all plugs are properly connected and power cord is plugged into the wall outlet. (If
the tree comes with a foot pedal, try stepping on the on/off button).
2. Turning the poles gently to make sure pole to pole are connected into place.
3. Please check for loose, broken or missing light bulbs and replace as needed.
Loose Hinge Pin
1. Extra hinge pins are included for repairing the hinges. Place the branch into the slot of the bracket.
2. Insert a new hinge pin through the hole and secure using the retainer washer.
(See Fig. D)
