1 Safety
6
Installation and maintenance instructions Energy
7
0020300877_01
▶
Make sure that the product is transported
by at least two people.
1.3.6 Explosive and flammable substances
To prevent explosions and fire:
▶
Do not use the product in storage rooms
that contain explosive or flammable sub-
stances (such as petrol, paper or paint).
1.3.7 High temperatures
To prevent burns:
▶
Only carry out work on components once
they have cooled down.
To prevent material damage that is caused
by heat transfer:
▶
Only solder connectors if the connectors
are not yet screwed to the service valves.
1.3.8 Heating water
Both unsuitable heating water and air in the
heating water may cause material damage to
the product and in the heat generator circuit.
▶
Check the quality of the heating water.
(
▶
If you use non-diffusion-tight plastic pipes
in the heating installation, ensure that no
air gets into the heat generator circuit.
1.3.9 Neutralisation device
To prevent contamination of the waste water:
▶
Check whether a neutralising unit must
be installed in accordance with national
regulations.
▶
Observe local regulations on neutralising
condensate.
1.3.10 Safety devices
▶
Install the necessary safety devices in the
installation.
1.3.11 Risk of death from escaping flue gas
If you operate the product with an empty con-
densate trap / siphon, then flue gas may es-
cape into the room air.
▶
In order to operate the product, ensure that
the condensate trap / siphon is always full.
1.4
Regulations (directives, laws,
standards)
▶
Observe the national regulations, stand-
ards, directives, ordinances and laws.
1.5
List of relevant standards for Great
Britain and Ireland
▶
You can find a list of relevant standards at
https://www.glow-worm.co.uk/standards.
