Glomex DANUBE NEO R500N, User And Installation Manual

Page: 59 / 146

57
www.glomex.it
DANUBE “NEO”
(R500N - R500N/DCSS)
ENGLISH
NOTA: the R500N/DCSS antenna can be used
with dCSS decoders only. Using the optional
Glomex splitter, to be installed after the control unit,
it is possible to connect up to max 15 dCSS
decoders to the Glomex TV satellite antenna.
S
WARNING
Follow the instructions given in the decoder’s
installation manual to configure your dCSS
decoder. It is important to leave the 1940MHz
(UB16) free when selecting the frequencies on
your decoder. In fact, this frequency is used by the
Antenna Board of the GLOMEX satellite TV
antenna. Each decoder connected to the Glomex
TV satellite antenna must use a different frequency.
SCR + dCSS Frequencies
Fig. 3
DANUBE “NEO” R500N DANUBE “NEO” R500N/DCSS
Component Component
(1) Antenna unit (1) Antenna unit
Control unit with wall-mounting bracket Control unit with wall-mounting bracket
(3) Coaxial cable, 10 m long, for antenna - control
unit connection, with integrated protection (antenna
side) (3) Coaxial cable, 10 m long, for antenna - control
unit connection, with integrated protection (antenna
side)
(4) Coaxial cable, 1.5 m long, for control unit - sat
decoder connection (4) Coaxial cable, 1.5 m long, for control unit - sat
decoder connection
(5) Multi-output splitter (optional)
(6) Coaxial cables for additional splitter - decoder
connection (optional)
Frame for built-in installation Frame for built-in installation
Roof fairlead (enables cable and connector
passage) Roof fairlead (enables cable and connector
passage)