User manual
12
CH+/ CH- button to shift channel as like or press OK button to pop up TV Channel List and select a
preferred channel to enjoy. Or press TV/ R button to toggle between TV channel and radio channels.
Channel scan
Select and enter submenu Channel Scan which contains the following contents:
•
Scan Mode: By Channel or By Frequency.
Scan a particular channel by the exact channel Number or frequency. For By Channel mode, user will
have to set Scan Band, Ch No. and Network Search in the meantime. For By Frequency mode, user will
have to set the correct Frequency and Bandwidth data together.
•
Scan Band: VHF or UHF.
Scan channels within either VHF (Very High Frequency) or UHF (Ultra High Frequency) or both bands.
Such setting is active only in By Channel mode.
•
Ch No.: Channel 5~12 ( VHF), or Channel 21~69(UHF)
Choose the exact channel number to search for a designated channel. Active only in By Channel mode.
•
Frequency: 174~230MHz (VHF) or 470~862MHz (UHF).
Enter the correct frequency parameter of certain channel for scan. Active only in By Frequency mode.
•
Band Width: 6MHz, 7 MHz or 8 MHz.
Set the right bandwidth of the region where the receiver is in use. Active only in By Frequency mode.
•
Search:
Click Search with OK button to start scanning manually.
•
Signal Intensity:
•
Signal Quality:
The green Signal Intensity bar and yellow Signal Quality bar indicate the real-time receiving condition
of the signal.
Use
▲
/
▼
button to select a setting item, and
◄
/
►
button to shift the options. Press EXIT button to
leave.
Note: The frequency system automatically depends on the region where the receiver is in use, and the
actual frequency setting should follow the practice strictly.
When channel scan is under way, user can check the relevant parameters concerning the process and
progress:
Frequency band, Frequency, Modulation type, Guard Interval and FFT mode namely.
Aerial Adjustment
Select Aerial Adjustment and open the menu:
Tuner Power: On/ Off
This setting is designed to enable or disable active antenna depending on user’s needs.
LCN
LCN mode: On/ Off.
Use this setting to enable or disable LCN function. If LCN mode is On (enabled), the system will sort
the channels in an order preset in the signal stream; if LCN mode is Off (disabled), the system will sort
the channels in a routine order.
Note: When there is no LCN data in the stream, and LCN is enabled, the system will not sort the
