55069C – Reversing camera built into the license plate frame - 12V
Replace your conventional license plate holder with a version that includes a camera. You can
easily insert the cables for the license plate light. The vertical tilt of the camera can be
adjusted over a wide range.
Easy to install
Compatible with all cars
Adjustable camera
Wide angle view
Built-in 4pcs LED
RCA signal cable connecting to the display (the display is not part of the set!)
Power source:
12V
Camera viewing angle: 170°
Resolution:
648 x 488 px
Set includes:
1 pc license plate frame
1 pc reversing camera
1 pc set of cables
Size:
545 x 140 x 35 mm
Signal cable length:
6 m
Color:
Black
Material:
Plastic
Protection:
IP67
Warnings:
-
The surface of the sensor must be kept clean!
-
When reversing, always check the environment, look around and use the rear-view mirrors!
-
Reverse at low speed to react to unexpected situations!
-
Have the appliance installed by a specialist!
-
Disconnect the cable from the battery (+) terminal before installation.
Wiring:
1.
Connect the wires with the red connector to the reversing lamp connector and provide
adequate insulation.
2.
Connect the black cable to a ground cable or a point on the car body.
3.
Use the yellow RCA cable to transmit the video signal to the display.
4.
You can mount the camera in place of a standard-sized license plate frame.
5.
After mounting, place the license plate in the frame by inserting the upper edge of the
license plate from below under the camera bracket. (We recommend using double-sided
adhesive on the back of the license plate if required)