GLOBBER ONE K E-MOTION 10, Owner'S Manual

Page: 5 / 226

3 - ASSEMBLY
1. Insert the steering column into the threaded axle, do not tighten the clamp at this
stage.
2. Place the handlebar in the housing at the top of the steering column and secure
the clamp with the two screws.
3. Align the handlebars with the wheel axle, then tighten the clamp at the bottom of
the threaded axle.
1 2 3
4 - MODE OF OPERATION AND USE
ON/OFF FUNCTION
- This scooter has a Kick Start function.
- To start, push your scooter forward. The battery lights signal on the deck will turn
on; you are now in the “ON” mode.
- Your E10 will turn off automatically after 1 minute of inactivity; the battery lights
signal will also go off.
START-UP
- You are in a position to start:
To engage the motor, 2 actions are necessary.
Place your foot directly on the accelerator pressure sensor.
Push your scooter to reach a speed of 5km/h.
Be aware that once your motor is turned ON, reducing your speed below 5km/h
does not automatically cut the motor, see paragraph STOP regarding the
instructions for stopping the motor permanently.
CHECK SPEED
To control the speed, you can simultaneously OR independently use the brake
located at the rear of the scooter (mudguard) or/and use acceleration sensor
located on the top of the deck (Press with your foot to accelerate, remove your foot
to slowdown)
- Once the electric motor is engaged, it will accelerate until reaching the cruising
speed of 12 km/h.
- You can control the speed with the electronic brake located at the rear: pressing
this brake automatically stops the motor. This system generates both mechanical
and electrical braking that reduce again the braking distance.
- WARNING! Engaging the brake (mudguard) automatically shuts off the motor and
only until you press the brake. If you release the brake, the motor automatically
engages again.
STOP
To stop the motor completely, press the brake continuously for 3 seconds and
wait for the scooter to stop safely to get off the platform. The lights at the rear
brake will also light up when engaging. At any time you can remove your foot
from the acceleration sensor to automatically shut down the motor for example in
an emergency. The battery will automatically turn itself off when the motor is not
engaged for more than 60 seconds.
5
ENGLISH