G l o b a l s t a r M C M - 4 M
G E N E R A L T R O U B L E S H O O T I N G
4-1
4.
Cascaded MCM-4M Set-up
1.
Follow instruction above in Section 3.5 MCM-4M Installation for up to 4 MCM-4M units.
2.
Install the second, third or fourth MCM-4M units in the preferred location within 12 inches of the
previous MCM-4M unit. (see figure 4-1)
3.
At the front panel of the MCM-4M units Install an Ethernet “Crossover” cable into the Cascade
Ethernet to the subsequent unit Ethernet connector between all operational units as shown in
Figures 4.1, 4.2, 4.3.
4.
Set the “Thumbwheel Switch” to position 1 on the primary MCM-4M Unit.
5.
Set the “Thumbwheel Switch” to position 2, 3 or 4 on the subsequent MCM-4M Units depending
on how many units are cascaded.
6.
Route Ethernet Cable to planned locations of remote client equipment from the Primary MCM-4M
unit. The Ethernet port on the secondary MCM-4M units must be left open.
Do not connect an
Ethernet cable to the secondary units while in cascade operations.
7.
Turn on power to all operational units. Primary unit will auto configure secondary units to use all
modems after a short initialization time(30-45 seconds)
4.1.
Multi Channel Modem (MCM- 4M) 2 Unit Cascaded Set-up Front Panel
Figure 4-1 MCM-4M 2 Unit Cascaded Front Panel
4.2.
Multi Channel Modem (MCM- 4M) 3 Unit Cascaded Set-up Front Panel
Figure 4-2 MCM-4M 3 Unit Cascaded Front Panel
Summary of Contents for MCM-4M
