DreamPlug User Guide –page
6
/
12
D. Connect to JTAG board
2. Connect 8 pin JTAG cable
1. Connect 4 pin UART cable
3. Connect Mini USB cable here.
The other end connects to
computer’s USB port.
This is the standard 20pin JTAG connector which has the same pin signals as 8 pin cable
Normally, this switch (or jumper wire) should
be on the left side for UART selection
This DC 2.5V is for Dream Plug CPU
e-fuse programming only, do not use it
for other purpose.
