1.
PC CONTROL
：
Show the status of input-output selection,
EDID info and so on.
TCP/IP: This port is the link for TCP/IP controls, connect to an
active Ethernet link with an RJ45 terminated cable.
RS232: Connect to a PC or control system with D-Sub 9-pin
cable for the transmission of RS-232 commands.
2.
Power port
：
Use included DC adaptor to power the matrix
switcher.
3.
IR EXT: This port is local IR receiver for extending the IR
signal. Connect with Wideband IR Rx.
4.
IR RECEIVER: These ports are IR Matrix input ports. Connect
with Wideband IR Rx.
5.
IR TRANSMITTER:
These ports are IR Matrix output ports.
Connect with Wideband IR Tx.
6.
COAXIAL OUTPUT: Audio output area, each ports are come
from HDMI output port. For example: the audio signal of coaxial
out A is come from HDMI output A.
7.
HDMI INPUT Area
：
Connect HDMI sources. LED 1-8
illuminate when the HDMI signal plug in corresponding input port
with HDMI cable.
8.
HDMI OUTPUT Area
：
Output for displays, AVR etc
. LED A-H
illuminate when the displays plug in corresponding output port
with HDMI cable.
IR BLASTER (TX)
To control the source: Plug IR Blaster into IR TX port of
transmitter unit; place blaster in front of the IR eye of the source.
To control the display: Plug IR Blaster into IR TX port of receiver
unit; place blaster in front of the IR eye of the display.
Page 9 of 13
