Alarm Password Management
Modify PIN code
PIN code can be modified under disarm mode as following;
1, Input default code(default factory code ‘1234’), LED
starts flashing for 30 seconds,
2, Enter new four digits PIN code,
3, Red LED light stop flashing to confirm new code is set
successfully and turn to disarm mode.
NOTE: The first digit of new code can’t be ‘4’.
Video record standard time setting.
Connect the alarm with PC using USB line, it will
automatically setting the record standard time, all record
time will keep same with your computer when recording.
Installation
1. Free stand in the horizontal surface.
2. Or install the alarm on the wall , preferably front the door
about 1~1.5M above ground.
2. Remove the back cover and fix it to the wall using the
screws supplied.
3. Then the alarm body can be snapped into place on to the
back cover and secured using the screw at the base.
Note: This alarm unit also can be used as free standing.
Alarm Operation
Arm the Alarm Unit
Press keypad number 4 and a confirmation tone will indicate
that the alarm is armed. You have 30 seconds to vacate the
area. After this time, if motion is detected, alarm will siren.
Disarm the Alarm Unit
Input 4 digits security code within 5 seconds. This will
disarm the alarm. After this time, alarm will sound 30
seconds, then auto reset for next motion detecting.
Check the video record
Under disarm mode, connect alarm unit with PC via USB
line(included), you can find the “record” files in my
Computer.
Each Video record is 30seconds for each PIR detection.
Detection range
The motion detector area of the alarm unit has 8m far away,
60° horizontal and 120° vertical.
Care and Maintenance
To clean the case, simply use a soft slightly damp cloth with
water and wipe dry immediately.
Caution: Never use chemicals to clean the case, as they may
cause damage to the plastic and cause alarm not available.
Troubleshooting
The unit does not sound when the batteries are installed
Ensure that the batteries are connected correctly according
to the diagram in the battery compartment.
The alarm does not arm
Ensure that the back plate of the alarm unit is secure to hold
the batteries in place and that the red light comes on when
the ‘arm’ or ‘disarm’ buttons are pressed.
The red light on the base of the alarm is on
This is‘ Battery low indicator. The batteries need replacing.
Battery precautions
Use appropriate size batteries.