The air inlet, used for connecting air supply, has standard 1/4” NPT American Thread.
Line pressure should be increased to compensate for unusually long air hoses (over 25 feet).
Minimum hose diameter should be 1/4” I.D. and fittings should have the same inside
dimensions.
Maintenance
Other factors outside the tool may cause loss of power or erratic action. Reduced
Compressor output, excessive drain on the air line, moisture or restriction in air pipes or the
use of hose connections of improper size or poor condition may reduce air supply. Grit or
gum deposits in the tool may cut power and may be corrected by cleaning the air strainer
and flushing out the tool with gum solvent oil or an equal mixture of SAF#10 oil and
kerosene. If outside conditions are in order and tool is out
-
of
-
warranty, clean, reassemble,
and re
-
lubricate, or take tool to any air tool service center. For tools in warranty period, send
tool direct to Warranty Center.
