4
Assembly
Assembly Instructions
Attach wall mount to a flat surface using the screws provided.
Attach handle to the end of strut with the telescopic wand adjustment
Pressing down the locking tab, slide shorter strut over longer strut until
locking tab catches. Insert assembled handle into the base until it locks
in place.
Loosen the telescopic wand adjustment to lengthen or shorten the
handle to the desired length and then tighten the telescopic wand adjustment
Insert battery into battery compartment unit it “snaps” in place. Connect the
power adapter and allow the unit to charge for 10 hours (NM). Also you can
remove the battery from the unit and charge the battery directly.
You can use the machine when the LED charging indicator light changes from
red to green. Keep charging about one hour after the LED charging indicator
light turns green, it can extend the runtime.
The LED charging display will light when charging.
NOTE: The unit will not charge if left in the ON position.
It is recommended that you remove the power adapter from the unit once
the unit has completely charged.
1
2
3
1
2
3