Ⅲ
. Matrix mode
FIG.7 MATRIX CONNECTION DIAGRAM
1. Connect SYV-75/RG59 coaxial cables from TX RF OUT into the output ports of DTV mixer.
2. Connect SYV-75/RG59 coaxial cables from RX RF IN into the output ports of DTV mixer.
3. Connect input ports of two DTV mixers with one SYV-75/RG59 coaxial cable.
4. Connect HDMI cables from DVD/BD player into the HDMI input port of TX.
5. Connect HDMI cables from TV/Monitor into the HDMI output port of RX.
6. The need for communication with the TX and RX set to the same channel.
7. Connect 5V power supply to the TX&RX, and inserted into the power socket.
Notes:
1. In normal conditions, transmission distance up to 500 meters by SYV-75-5 coaxial cable and no
need amplification. For the high-frequency RF signal haves signal attenuation, signal strength will
become weakened after adding DTV network mixer and multi output.
2.
If the signal frequency is high, the transmission attenuation is greater.
So choose low channel for
long-distance transmission.
3.
When the transmission distance is short (less than 100 meters), because the signal is too strong,
RX may protect and display "NO SIGNAL" to TV.
So now you should choose high channel or adding
attenuator in coaxial cable for the signal attenuation.
4.
With the channel set and frequency values refer to the table below, and channel selection switch
setting method is as follows:
e.g.1 CH1
（
0000 0001
）
e.g.2 CH11
（
0001 0001
）
DVD/BD/STB
RX
RX
DTV Mixer
HD camera
TX
TX
HDMI
cable
Coaxial cable
TV/Monitor
HDMI
cable
Coaxial cable
Coaxial cable
Coaxial cable
Coaxial cable
HDMI
cable
HDMI
cable
TV/Monitor
Summary of Contents for HDEX009M1
Page 9: ......
