Safety automatic shut off and heat protection thermostat system
The portable beauty steamer machine is with good safety function. When the water level
is too high or too low, it will automatically stop working. After adding or reducing water,
you should restart the unit for reworking. You won’t worry about too much hot water spit
out causing injury or too little water which damages the unit.
Procedure for installation and operation(as shown in the figure)
1. Place the device onto the support stably
2. Check if the seal for the hot water cup has been tightened up.
3. Fill water from the water-filling opening until the water level gets close to the high limit
for water filling
4. Switch on power
5. Press the push-button on the operating panel to heat the device or press bactericidal
button.
6. Please drain all the water out of the water cup when the device is not used for a long
time.
Cautions:
1. Do not place the device upside down or tilt it when it is in operation
2. Do not operate the device if no water is available
3. Clean the water cup frequently, and the power supply plug must be unplugged before
the water cup is removed.
Repairs:
This device has been tested and examined strictly before factory delivery. In case any
fault occurs during its operation, please send the device to our company’s distributors or
designated repair shops for repairs. Non-professionals shall not disassemble the device.
An anti-water-spray mechanism is specially designed for the device.
The device will not spray but give an alarm in case there is water, which indicates the
anti-water-spray mechanism is working.
Water level is too high
Switch off power supply
drain our water
re-strat
Water is too turbid
Switch off power supply
clean
change water
re-start
