DOCUMENT NO. 1000564 REV. E
16
Con
ti
nue rou
ti
ng the cable to the solar charge controller lo
cati
on and cut to the appropriate
length. Mark the Posi
ti
ve (+) cable prior to cu
tti
ng. Remember to leave some extra cable to make
the fin
al connec
ti
ons easier.
At the charge controller end of the PV cable, strip 3/8” of insul
ati
on to expose the copper wire.
Next, cut the loop on one of the included ATC inline fuse holders and strip 3/8” of insu
lati
on from
each end. Be sure a fuse is NOT in the holder. The fuse will be inserted in a later step. Crimp a
splice connector to one end of the fuse wire and one of the small ring terminals to the other. Do
not use the large ring terminal at this step. Crimp the other end of the splice connector to the
po
siti
ve (+) wire. Crimp another small ring terminal to the nega
ti
ve end of the cable. Do not
connect the cable to the charge controller yet. This will be done in a later step.
Route the 10AWG, 2-conductor cable from the charge controller to the ba
tt
ery lo
cati
on. Strip the
cable as above at the charge controller end and crimp small ring terminal to each wire. Do not
connect the cable to the charge controller yet.
At the b
att
ery lo
cati
on, cut the cable from the charge controller to the desired length. Remove
approximately 12” of the outer jacket of the 10AWG, 2-conductor cable. Strip the wire ends as
above and a
tt
ach the other inline fuse holder to the po
siti
ve wire. Make sure a fuse is NOT in the
fuse holder. Crimp a large ring terminal to the other end of the fuse holder and to the nega
ti
ve
wire. WARNING - Do not
locate the inline fuse holder elsewhere on the cable. For safest
in
stallati
on it must be located at the b
att
ery.
