Page | 6
LEGEND SERIES POOL LIFT OPERATING INSTRUCTIONS
Prior to using the Legend Series Pool Lift perform a test run of the lift empty. Once that
is completed and the lift is back to original position, make sure that the arm lifts are in
the up position and the seatbelt is unbuckled, once acknowledged you are ready!
Once you are in the seat, buckle the seatbelt (make sure it is snug) and lower the arm
rails if installed. Before you attempt to operate the lift, make sure the pathway is clear
from any obstacles.
Once you have the 2 button easy controls in your hand, press the arrow that specifies
down, keep in mind you don’t have to go to the bottom of the cycle, you can stop the
lift whenever you deem comfortable to exit the lift. However when exiting the pool
while on the lift, you should complete the cycle back to the top to have a completely
safe exit from the pool.
Once submerged into the pool, unbuckle the seatbelt and raise the armrest if installed,
and slide off of the seat. Once you are done with your pool activity, make sure the seat
is lowered sufficiently to allow you too easily slide back into the chair. Once you are
seated, buckle the seatbelt and make sure that it is snug, lower the armrest if installed.
Next, to raise the lift chair out of the pool, make sure you press the button/arrow that
represents up on the control. Apply continuous pressure until the lift comes to a
complete stop at the end of the complete up cycle on the deck. You now can unbuckle
the seatbelt and raise the arm rest if installed and exit the unit. Staff will turn the key
on the hand control or front of the control panel to re-lock the lift when the pool is not
in operation. In the unlikely event that the lift does not return from the water using the
hand control, have an attendant press the emergency return button on the front of the
control box and the lift will return to pool side.
