Operating LaserLyte With 5V PS1/PS4
Power Supply
Operating LaserLyte With 4.5V Battery
Box
If you have purchased an extension lead:
1. Plug the male DC Jack end of the extension lead into the DC socket on the PS1/PS4
2. Plug the male DC Jack of the LaserLyte cable into the DC socket on the extension lead
If you have not purchased an extension lead:
3. Plug the male DC Jack of the LaserLyte cable directly into the DC socket on the PS1/PS4
If you are using more than one laser with the PS4 then repeat the above steps until all your lasers are
connected.
4. Connect IEC plug to PS1/PS4
5. Plug the PS1/PS4 into a mains socket
6. Switch on PS1/PS4 with the optional key switch or at the mains socket
For further information please refer to the Universal Power Supplies datasheet.
The battery box power supply provides power in applications where it is impractical to use a permanent
power source.
1. Remove the lid of the box by unscrewing 4 x Phillips head screws
2. Insert 3 x industrial AA batteries into battery compartment
3. Replace the lid
4. Plug the DC jack end of the LaserLyte-Flex cable into the DC socket on the battery box
5. Switch on the power supply using onboard rocker switch
For further information please refer to the Battery Box datasheet.
Focus Adjustment
The focus distance of your laser upon delivery will be collimated unless requested otherwise. This can
be adjusted as follows:
1. Insert focus key into focus control hole on laser barrel.
2. Turn until desired focus is achieved (if the key turns to maximum limit re-insert and continue to turn
until focus is achieved).
