As of 01/2020
Page 3 of 3
Clean using a mild dish soap and warm water. Apply the soapy mixture to a clean cloth and scrub away the dirt. Rinse with
clean water. If you have stubborn dirt inside the grooves and divots, mix 1 part bleach to 2 parts water, and wipe using a
clean cloth. If needed, scrub with a soft bristle brush and then rinse.
Cleaning Tips:
Step 7
With two people, carefully lift the table top and position the slots
in the top underside frame with the three (3) base legs, slide the
top down on the legs. Ensure each base leg is fully engaged
in the slot and the top is resting even and level.
A
A
B
B
B
C
C
C
Step 8
Remove the item used to support the arm assembly to allow for
proper positioning. Ensure the bases are resting flat on the
mounting surface, position the horizontal arm with the pre-drilled
hole in line with the base leg. The distance between the
bottom side of each support arm and the mounting surface
should be the same. Attach each arm to a base leg using a
3 1/2" hex lag screw and flat washer (A).
Verify the top is level, attach top to the vertical supports with 3 1/2"
hex lag screws and flat washers (B).
Attach the seat blocks to each base seat support using 2 1/2" hex
lag screws and flat washers (C). See Illustration 'H'.
TM
