MAINTENANCE
1. Avoid using the vacuum for more than 20 minutes at a time.
2. Clean the filter and tank after every use. Do not run the vacuum with a dirty
filter or full tank.
3. Dump any dirty water after vacuuming to prevent corrosion.
4. Dry all wet surfaces with a paper towel or dry cloth.
5. DO NOT vacuum for more than 20 minutes at a time, the battery will overheat.
6. Allow the battery to come down to room temperature before recharging
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Battery charge is low
Charge battery
Battery is not properly inserted
Remove and reinstall battery
correctly
On/off switch is broken
Replace on/off switch
Tank is full
Empty and clean tank
HEPA filter is clogged
Clean/replace the filter
Blockage in nozzle or hose
Remove and clean nozzle/hose
Battery charge is low
Charge battery
Motor stops when vacuuming
Battery charge is low
Charge battery
Poor contact between battery and
charger
Remove and reinstall battery
correctly
Battery is too hot
Wait for battery to cool to room
temperature before charging
Battery pack fails to charge
Reduced suction
Motor won't start
TROUBLE SHOOTING
CHARGING INSTRUCTIONS
1. Slide battery pack onto charger upside down until it clicks in place.
2. Plug the charger into a wall outlet. The RED charge indiciator LED should
illuminate. Battery should reach full charge in approximately 60 minutes.
3. GREEN charge indicator LED should illuminate when battery is fully charged.
Unplug the charger.
4. Press the release button on the battery and slide the battery out of the
charger.
NOTE: the battery may have become hot during charging, allow the battery to
return to room temperature before use.
NOTE: the battery ships partially charged to avoid deep discharge damage,
however you still must fully charge the battery before your first use.
Cordless Wet/Dry Vacuum
5
