10. To clean pipe connectors remove them from the vacuum. Pipe
connector flange slides out of channel. Wash connectors under
running water.
11. To adjust motor speed, turn motor speed dial located above
power switch.
12. To clean vacuum tank, remove vacuum cover and wash tank in
sink with soapy water.
MAINTENANCE
1. Avoid using the vacuum for more than 20 minutes at a time.
2. Clean the filter and tank after every use and replace the dustbag.
Do not run the vacuum with a dirty filter or full dust bag.
3. Dump any dirty water after vacuuming to prevent corrosion.
4. Dry all wet surfaces with a paper towel or dry cloth.
5. DO NOT vacuum for more than 20 minutes at a time, the motor
may overheat.
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Plug is improperly connected
Reconnect plug
Power cord is damaged
Replace power cord
Outlet is not producing voltage
Use different outlet
On/off switch is broken
Replace on/off switch
Blockage in brush, hose, tube
Remove blockages
Filter is clogged
Clean or replace filter
Dust bag is full
Replace dust bag
Vacuum has been running for
more than 20 minutes
Turn vacuum off for 20 minutes
until next use
Blockage in brush, hose, tube
Remove blockages
Hot air coming from air outlet
Reduced suction
Motor won't start
TROUBLESHOOTING
Corded Wet/Dry Vacuum
5
