1 / 1
6.1.
0
REPLACEMENT
OF TYRES AND WHEELS
General informations:
The tyres used are of the «Tubeless» type and so
every repair of a hole in the tyre must be done by
a tyre specialist according to the methods used
for this type of tyre.
Related topics:
Aligning the cutting deck
Tyre pressures
Front ........................... (Tyres 13 x 5.00-6) 1,5 Bar
(Tyres 15 x 5.00-6) 1,0 Bar
Rear ............................................................ 1,2 Bar
1
1
2
3
A) Tyres
After replacing one or more tyres or the wheels, it is
always necessary to check the pressure and to check
the alignment of the cutting deck
WARNING
Replace distorted wheel rims as they could impair the
tyre’s hold.
B) Wheels
The wheels are held by a snap ring (1) which can be
removed with the help of a screwdriver.
NOTE
If a wheel is jammed onto the shaft, use a releasing
spray directing around the splining hole.
On assembly it is advisable to spread grease on the
shaft to facilitate the next wheel removal.
For the front wheels:
replace the shoulder washer
(2) and the flexible ring (1) with the bevel facing
inwards.
For the rear wheels:
replace the shoulder washer
(2) and the flexible ring (1) with the bevel facing
inwards and check the axial gap of the wheel on the
shaft; if it is greater than 3 mm, a spacer (3) must be
fitted between the wheel hub and the shoulder wash-
er (2).
MODEL YEAR 2016
N…102 Hy
N…102
WORKSHOP MANUAL
WORKSHOP MANUAL
BACK
