F12, User Manual, V2 12.2020
MICRO SHAKE 1200
Page 23 of 25
13. DECONTAMINATION
Check whether all the tubing is properly connected. Switch on the instrument.
13.1.
DECONTAMINATION PROCEDURE
If the instrument is to be shipped after being exposed to potentially hazardous material, it should be
decontaminated. The following procedure outlines the method to decontaminate the instrument before
packaging and shipment.
13.2. PURPOSE OF DECONTAMINATION
Decontamination minimizes the risk to all who come in contact with the instrument during shipping,
handling, and servicing.
13.3. GENERAL CONSIDERATIONS
Any laboratory instrument that has been used for clinical analysis is considered a bio-hazard and should
be decontaminated prior to handling. Intact skin is generally considered an effective barrier against
infectious organisms; however, small abrasions and cuts may not be always visible. Prophylactic gloves
must be worn when handling instruments that have not been decontaminated. Gloved hands should be
considered contaminated and must be kept away from eyes mouth and nose at all times.
Mucous membranes are considered as the prime entry routes for infectious agents. Wear eye protection
and a surgical mask when there is a possibility of aerosols.
Eating and/or drinking while decontaminating instruments is not advisable.
13.4. PROCEDURE
•
A solution of 0.5% Sodium Hypo Chlorite (NaOCL) solution (Bleach) is used. Commercial
bleach is 5% NaOCL; household bleach is 3% NaOCL. When using commercial bleach, use a
10:1 mixture; if using household bleach, a 6:1 mixture is required. This is a caustic solution. It is
important to wear gloves and eye protection when handling it.
•
Wipe down the carrier and all exposed surfaces of the unit with the bleach solution. Remove the
top shroud of the instrument and wipe down the top surface of the instrument base, as well as the
inside of the top shroud.
•
Reassemble the unit and discard the used gloves and towels.
