•Page
globalcontract.com
3
• Spring 2019
GLOBAL
Contract
Wheel Controls
How to set memory:
Run/Drive the table to the position you will store,
sitting or standing.
(This device have 5 memories position memories)
Press menu “stand” icon 1 time to come
to set memory menu.
Calibrate:
Measure the distance between the floor and the top
of the table sheet.
Press menu “stand” icon 2 times to come
to calibrate menu.
Use arrow up and down to navigate to set memory
setting.
Press Menu/Enter, and the value are stored.
The display confirm by flashing 3 times and then
returns to normal mode.
Press Menu/Enter to confirm
Press Menu/Enter to confirm
Press Menu/Enter, and the value are stored.
Press Menu/Enter, and the value are
stored.
Adjust the figures to the selected value with the
arrows up or down.
1
5
CAL
28
.
0
Upper limit:
Set the upper limit if there are limited
space in height.
Press menu “stand” icon 3
times to come to set memory menu.
Units:
Choose between metric or imperial
system.
Press menu “stand” icon 5
times to come to set memory menu.
Error codes:
Reset Away:
Press menu “stand” icon 6
times to come to set memory menu.
Lower limit:
Set the lower limit if there are device/
equipment which could create a risk
of pinching or risk for table damages.
Press menu “stand” icon 4
times to come to set memory menu.
Adjust the figures to the chosen level
with the arrows up or down.
Press Menu/Enter to confirm.
Press Menu/Enter to confirm.
1. Hard stop
2. Back off
3. Soft top
4. Waiting for button
5. Waiting for button release.
6. Motor lost
Overheating. Thermometer flashing,
wait 10 minutes for motor cooling.
Adjust the figures to the chosen level
with the arrows up or down.
Adjust the figures to the chosen level
with the arrows up or down.
Press Menu/Enter, and the value are
stored.
Press Menu/Enter, and the value are
stored.
Press Menu/Enter, and the value are
stored.
Press ‘down” and hold until the columns
have gone to the lowest position.
Do reset if any parts have been changed
of if you discover interference between
the columns.
Please note that the figures count
from the table top surface.
Please note that the figures count from
the table top surface/ calibrated level.
UL
50
.
0
LL
27
.
5
UN
RES
3
